MACLOGGERDX FT8 SERIAL
I am open to any other thoughts or suggestions, Top end Fixed now bottom end still having the issue Below 1100 to 1200 HzSome or most radios also have an RS-232 port, so you actually have two serial ports. G4WJS - I am using a USB cable between computer and rig with MacLoggerDX but can’t use it with WSJTX at same time For rig control on iMac In fact, it has been a year this month, and I just learned how one function actually worked! It took a few months with my radio when it was new last year to feel like I could do most of what I wanted with it. Get to know your radio and what is adjustable, what isn’t, and where to make the adjustment if you can. If not, you may need to use the SSB (Upper sideband) mode instead of Data mode. If this is true, you may need to go into menus or otherwise try to modify the bandpass specifically for the Data mode. I don’t have this radio, but I’m assuming that like mine, the Data mode puts additional restrictions on the bandpass. I don’t remember if your current symptoms said you were in USB or USB-Data mode. I still have the problem below about 1100 to 1200 HzĪG0N - Is this a xmit setting or software, I have equalization off on Xmitter using Mic input via Rigblaster AdvantageI’m not sure what the word “this” in the above question is referring to. This fixed the top end and I can go all the way to 3000 Hz with no power fluctuation now where before I had problems above 2600 Hz.
MACLOGGERDX FT8 MANUAL
N7GHZ - I reset TX BPF SEL to 50-3050, and HCUT FREQ to 4000 and LCUT FREQ to OFFThis seems like it would be the right step, but you will need to dig into your manual and figure out what all affects the actual transmit bandpass. would this be a problem on the low end as a result? Thanks, Dale - N5HT I still have the problem below about 1100 to 1200 Hz AG0N - Is this a xmit setting or software, I have equalization off on Xmitter using Mic input via Rigblaster Advantage G4WJS - I am using a USB cable between computer and rig with MacLoggerDX but can’t use it with WSJTX at same time For rig control on iMac I am open to any other thoughts or suggestions, Top end Fixed now bottom end still having the issue Below 1100 to 1200 Hz W5VY - Not sure I am getting the Xmit shift in frequency you mentioned given not using WSJTX rig control rather MacLoggerDX rig control currently. I reset TX BPF SEL to 50-3050, and HCUT FREQ to 4000 and LCUT FREQ to OFF This fixed the top end and I can go all the way to 3000 Hz with no power fluctuation now where before I had problems above 2600 Hz. Thank you all ! KE4PT - I am using 3 KHz filter N7GHZ - Yes Hz not KHz my bad. On Wed, at 10:33 PM wrote: Wow, tremendous number of responses.